MOTOR OPERATION 1 3P ABN 54C ABN 64C ABN 104C

Specification of

Remote Control Switches consist of Motor Operation

1. Motor Operators can also be operated by manual. The motor drives a mechanism which switches ABN & ABS toggle handle to the "On" and Off/Reset"
2. The manual actuator handle is located on the fron of the cover
3. Mnaual or Automatic operation can be selected.
4. Applicable to,2,3 and 4 pole breakers

Manual Operation

1. Insert the manual handle into the slot of Motor operator surface and rotate it clockwise
2. it must be rotated just 180 derajat clockwise for safe operation of micro switch in the motor operator
3. Return the manual handle after the manual operation
4. Turn the slide switch back to the position of Auto

Automatic Operation

1. Set the slide switch to Auto, then internal power is closed automatically
2. Operating frequeny should be less than these below regulated values MOP-M1-M3, M7 (120 operations per hour), MOP-M4 (60 operations per hour), MOP-M5, M6 (20 operations per hour)
3. Use the On/Off switch in the range of regulated values.
4. it may interfere near communication equipments because of internal switching power supply. it is recommended that a noise filter be installed to power supply
5. Please do not input On/Off signals at the same time during the automatic operation
6. If the circuit breaker has a UVT attached inside, charge a UVT on the rated voltage before performing Motor Operator.